Compu-TTY KBS300RX Instrukcja Obsługi Pobierz pdf (Strona 14)

BED SHAKER LED INDICATOR

1 Main LED:

• Turns ON when there is a channel triggered by an alarm in the system.

• Low flashing when there is AC power failure.

• Fast flashing for battery low warning. It needs to be recharged soon.

2 Channel indicator LEDs:

• Turns ON to indicate the corresponding channel has triggered the receiver.

• Flashing to indicate a transmitter battery is low.

NOTE: The supplied battery of KA300TX transmitters can last more than 2 years under normal conditions.

If one transmitter battery is getting low, it is recommended that you change all of the

transmitter batteries.

KBS300RX is designed to wake you up when the alarm triggered. It will not stop until

you are aware of the alarm and recognize the source that caused the alarm. To stop the

vibrator on the KBS300RX press the reset button. However if the source continues to

send an alarm signal to the bed shaker receiver, the bed shaker will reactivate after a

two second pause.

INSTALLING THE KA300 SYSTEM FOR FIRST TIME

• Plan the fire alarm system on a drawing with desired channel indicator when

the alarm triggers.

• Record the operation code to the first page of the manual.

• Setup the operation code and channel jumper for all KA300TX transmitters.

Turn on and set aside.

• Install battery for all receivers KA300RX and KBS300RX.

• Plug in power supply and let it charge for one hour.

• Do the operation code learning process for each set. Turn the KA300RX on.

Press and hold the test button on KA300TX for two seconds. One LED on the

KA300RX will become stable and the code learning process is finished. If there

are several more codes, repeat the above process, if there is only one operation

code for all KA300TX Transmitter, program the KA300RX with one KA300TX.

CHAPTER 3 (CONT.)

Main LED

Channel LED

Test Button

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 20

Brak uwag

Compu-TTY KBS300RX Instrukcja Obsługi Strona 14